The Evaluation Kits section provides electronic component datasheet, part technical information, part manufacturer, specs and sources. SupplyFrame free research information is provided directly from the electronics manufacturer or their franchised distributor. This section of the site lets you search across the eval kits library by part number or subject matter.
Most Popular Evaluation Kits
| Document Information | Manufacturer | |
|---|---|---|
 |
The FAN5336 Evaluation Board is a compact circuit including the FAN5336 MPX in an MLP package and two small capacitors which can provide regulated output voltage to the load. The inductor-Schottky diode combination and two typically valued resistors are also included to form a resistor divider to the feedback pin. A feed forward capacitor is provided for stability as well. The FAN5336 demo board, a completely assembled and tested surface mount board, provides easy probe access points to all inputs and outputs so that electrical characteristics and waveforms can be easily measured. Type: Evaluation Board |
Fairchild Semiconductor |
|
The TPS51200EVM evaluation board, HPA322A is designed to evaluate the performance and characteristics of TI's cost optimized DDR/DDR2/DDR3/LP DDR3 VTT termination regulator, the TPS51200. The TPS51200 is designed to provide proper termination voltage and a 10-mA buffered reference voltage for DDR memory which covered DDR (2.5 V/1.25 V), DDR2 (1.8 V/0.9 V), DDR3 (1.5 V/0.75 V), LP DDR3 (1.2 V/0.6 V) specifications with minimal external components. Type: Evaluation Board |
Texas Instruments |
|
NCS2535 is a triple 1.4 GHz current feedback monolithic operational amplifier featuring high slew rate and low differential gain and phase error. The current feedback architecture allows for a superior bandwidth and low power consumption. This device features an enable pin. This evaluation board uses a TSSOP16 package of the NCS2535 chip. Type: Evaluation Board |
On Semiconductor |
|
ADCPro™ is a modular software system for evaluating analog-to-digital converters (ADCs) without the need for expensive logic analyzers and complex analysis routines. Used alone it is suitable for performing analysis on data sets captured from ADC testing; when paired with a Texas Instruments ADC evaluation module (EVM) and suitable data capture card, it becomes part of a powerful evaluation package. Type: Evaluation Module |
Texas Instruments |
|
The DRV600EVM evaluation module demonstrates the capabilities and performance of the DRV600RTJ from Texas Instruments. Type: Evaluation Module |
Texas Instruments |
|
The STM32 evaluation boards provide complete development platforms for the STM32F10xB (128 K) and STM32F10xE (512K) series of ARM? Cortex!"-M3 core-based microcontrollers. They provide cost effective, flexible and open design solutions ideal for demonstrating device capabilities and rapidly evaluating features and peripherals. They include an STM32 microcontroller with high performance ARM Cortex-M3 core, full speed USB 2.0 interface, CAN 2.0A/B compliant interface, I2C, SPI, USART with smart card support and internal SRAM and Flash memory. Type: Evaluation Board |
STMicroelectronics |
|
The MAX2150 evaluation kit (EV kit) simplifies testing of the MAX2150 complete wideband I/Q modulator chip. The kit allows evaluation of the I/Q modulator, synthesizer, 3-wire programming interface, and power- management features. The EV kit provides 50Ω connectors for all signal inputs and outputs. Type: Evaluation Kit |
Maxim |
